exercises:2019_conexs_newcastle:ex3
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
exercises:2019_conexs_newcastle:ex3 [2019/09/10 14:50] – [MgO] abussy | exercises:2019_conexs_newcastle:ex3 [2019/09/12 09:30] – [Part 2: XAS calculations] abussy | ||
---|---|---|---|
Line 103: | Line 103: | ||
Do not forget to put in your work directory the files '' | Do not forget to put in your work directory the files '' | ||
- | To run the calculation, type in your terminal: | + | To run the calculation |
- | < | ||
- | ./cp2k.sopt -i MgO_opt.inp -o MgO_opt.out & | ||
- | </ | ||
After the calculation is finished, you can check the files created in your directory. First open the output file '' | After the calculation is finished, you can check the files created in your directory. First open the output file '' | ||
Line 164: | Line 161: | ||
<note important> | <note important> | ||
- | Now the input is ready, and can be run in the same way as before, just changing | + | Now the input is ready and it can be run in the same way as before, just remember to change |
- | + | ||
- | < | + | |
- | ./cp2k.sopt -i MgS_opt.inp -o MgS_opt.out & | + | |
- | </ | + | |
After the calculation is finished, open the output file '' | After the calculation is finished, open the output file '' | ||
Line 188: | Line 181: | ||
&DFT | &DFT | ||
- | | + | !where to find all-electron basis sets and potentials |
- | POTENTIAL_FILE_NAME | + | BASIS_SET_FILE_NAME |
+ | POTENTIAL_FILE_NAME | ||
UKS | UKS | ||
Line 345: | Line 339: | ||
<note important> | <note important> | ||
- | To run this calculation | + | To run this calculation |
- | + | ||
- | < | + | |
- | ./cp2k.sopt -i MgS_xas.inp -o MgS_xas.out & | + | |
- | </ | + | |
This calculation should take longer than the geometry optimization to run. Once it is finished, check the number of warnings and if the calculation converged. Sometimes it does not converge within the maximum number of iterations we set in the input file. If this is the case, you can increase the number using the keyword '' | This calculation should take longer than the geometry optimization to run. Once it is finished, check the number of warnings and if the calculation converged. Sometimes it does not converge within the maximum number of iterations we set in the input file. If this is the case, you can increase the number using the keyword '' | ||
Line 391: | Line 381: | ||
</ | </ | ||
- | For the MgS system, for example, run the calculation | + | instead of '' |
- | < | + | After the calculation |
- | ./cp2k.sopt -i MgS_dscf.inp -o MgS_dscf.out & | + | |
- | </ | + | |
- | + | ||
- | After the calculation | + | |
< | < | ||
Line 416: | Line 402: | ||
< | < | ||
+ | |||
+ | You can check the tutorial [[exercises: | ||
exercises/2019_conexs_newcastle/ex3.txt · Last modified: 2020/08/21 10:15 by 127.0.0.1